Magigoo Original

I've tried all sorts of bed adhesion products, but the most effective and easiest to use has always been Magigoo.

I was blown away after the very first layer. Magigoo holds strong when hot, and the parts pop right off once it cools. Customer for life.

My first choice when it comes to adhesives. Applied once, it holds through several print jobs before I need to reach for the bottle again.

My go-to for printing engineering-grade nylons. It helps with both adhesion and release, and since switching I've had zero issues.

Magigoo was the answer to years of warping on carbon-fibre nylon prints. It lasts a long time too: we only reapply after around ten prints.

One of the best performing solutions we've used. Extremely reliable, easy to apply and easy to clean up.

If you're printing engineering filaments like ABS, ASA or nylon, you really need this. Without it you'll either get too little adhesion or too much and risk damaging your print bed. This stuff hits the sweet spot.

An absolute game changer. I'd been fighting bed adhesion on my Ender 3 for a year and had nearly given up on 3D printing. Now my prints stick perfectly with no bowing, and clean-up is easy.

Excellent product for holding troublesome prints down. I'm not sure of the chemistry, but it activates with heat and releases as it cools. I print mostly PETG and PLA, very happy.

If you're looking for an adhesive, you're probably already frustrated. This makes things simpler. Don't remove parts while the bed's still warm though: let it cool fully and they lift right off on their own.

Magigoo made it possible to print parts that were designed to be difficult, on build plates that previously couldn't get past the first layer. The improvement carries through to more specialised plates too.

I needed parts resistant to concentrated acids and acetone, printed in a filament that basically only sticks to itself. After trying every setting and tape combination, Magigoo worked perfectly, with almost zero warping.